30% Off
ON
SAW MACHINE
Online Purchases Only
*OF SLIDING TABLE SAW
-76%
1/4 Inch Air Die Grinder, 25,000 RPM Free Speed,1/4 Inch (6MM) and 1/8 Inch (3MM) collet,Mini and Compact Size,Polishing Tool
Original price was: $86.00.$20.99Current price is: $20.99.
- Shipping
- Reviews (8)
- More Products
8 reviews for 1/4 Inch Air Die Grinder, 25,000 RPM Free Speed,1/4 Inch (6MM) and 1/8 Inch (3MM) collet,Mini and Compact Size,Polishing Tool
Add a review
-
Carpenters-Tools&Equipment
Small Square and Center Finder – Mini Square Tool with 11/32″ Center Marking Hole Woodworking, Carpenter Engineering Square, Center Marking Tool, Made in USA – Blue
Original price was: $32.00.$22.44Current price is: $22.44. -
Carpenters-Tools&Equipment
Irwin Tools 1794482 Magnetic Post Level
Original price was: $9.33.$5.74Current price is: $5.74. -
✅ Textile & Garment Machines
PPD 20 Sheets 8.5×11″ – Inkjet Iron-on Heat Transfer Paper for Black & Dark Fabric and T-Shirts – Premium – PPD-4-20
Original price was: $23.99.$21.84Current price is: $21.84.
Related Products
Metal Needle File Set Metal Files Files Tools for Metal Needle Files Small File set for Metal Work Flat File File Tool Steel File Hand Files for Metal Wood Plastic Jewelry Leather DIY 6 Pcs
Original price was: $13.99.$6.31Current price is: $6.31.
Jordan sluka –
Powerful
So far it has been working well! Has tons of power. It seems to have as much if not more capability as the snap on grinder that I use at work
Robert Evans –
Great value
Works well and would definitely buy again. The first one needed replaced because it didn’t work but the second one was great
Dr. V –
Works for me
This is a real deal. Works well for me. I use it to sand and polish wooden bowls that I make. I gave it 4 stars for 2 reasons. Number one, it must use much more than the advertised 2.8 cfm at 90 psi. My compressor runs more than when I use air tools rated at 4.0 cfm at 90 lbs. I have a polisher that is rated 15.0 cfm at 90 lbs and the compressor doesn’t run anymore than this die grinder. Number 2, as someone already stated, it is almost impossible to change attachments without removing the collet. Major nuisance. Otherwise, it has worked well for my needs.
dave –
Collet was small
I took my other die grinder and put a 1/4 inch carbide burr in it . I then put the collet in vise and ran the burr through it . It works perfect now . NOW all you have to do is loosen lock nut to change tools. A 1/4 inch drill bit might work . Go slow & straight
tom –
It does the job
Works well once you force your bits in. The shanks are a tad large for the tool so you have to force em in or remove the threaded sleeve all the way, push in the bit and then screw it down.
Scott Hargrove –
Great tool for the price
I’ve used this primarily for shaping/carving woodworking projects, and it does the job. Small, light, easy on the hands, which makes it accurate for the type of work I’m doing.
Maikel Verde –
Shop
Good
GR33NLigHT –
Not fit up male end
Junk inaccurate fit up .. not a good fit